Kiddy World plus Manuel d'utilisateur télécharger pdf (Page 23)

Check that the protection shield is snuggly and properly adjusted (Fig. 27).

- Make sure the protection shield buckle is locked in place.

- The protection shield is contacting your child and there is no gap

between the protection shield and your child's torso.

- A snuggly adjusted LATCH lower anchor belt should not allow any slack.

The LATCH belt should lie in a relatively straight line and be flat, without

sagging or twist. The protection shield should contact the child but not

press on the child's flesh or push the child's body into an unnatural

position.

Removing your child:

Open the protection shield by releasing the protection shield buckle, rotate

the protection shield across the front of the car seat and place the

protection shield on the vehicle seat beside the car seat.

Remove your child.

To remove car seat from the vehicle:

Press adjustment bar and loosen top tether

belt.

Unhook tether hook by pressing up on flat

spring (Fig. 28; No. 1) and sliding tether

hook off tether anchor (Fig. 28; No. 2).

While pressing red release button on

LATCH connector (Fig. 29; No. 1) pull

connector out and off LATCH anchor

(Fig. 29; No. 2).

NOTE; Placing knee in car seat and press

down will make release of LATCH

connector easier.

Fig. 28

Fig. 29

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Pas de commentaire

Kiddy World plus Manuel d'utilisateur Page 23